Satin Pairs

This filling stitch is a variation of the basic satin stitch block. Work two stitches side by side over two threads of the fabric. Pivot and work another pair. Continue the first diagonal row to the desired length. Turn and work the second row in the same manner. Repeat until the space is filled. To fill a larger area, the stitch may be worked over four threads of the fabric.

« Back to Stitches

Written by: Ryan

Edge Stitch

The Edge Stitch weaves in and out of the net and the darning and linen stitch threads. You must use both to get the over and under weave correct. The example shown has the edge stitch highlighted in pink.

« Back to Stitches

Written by: Ryan

Linen Stitch

The linen stitch, or point de toile, basically fills in the grid of a netted square with threads woven from top to bottom and side to side. The resulting appearance is like a loosely woven linen fabric. Sometimes the stitcher will add a thicker thread to create a border, scroll, stems, and other linear objects. This combination is called filet Richelieu. With the addition of other filling and raised stitches, the technique is called filet guipure.

The traditional linen stitch has two horizontal and two vertical threads per mesh square. It will be necessary to adjust the size of your thread or the number of stitched threads depending on the size of your netting. Usually a large dot or “X” is used on a chart to indicate the linen stitch.

It is important when doing the linen stitch that you go to the very bottom of the row/column and then through the adjacent hole to go up the next row/column. You want the thread to loop around the net thread between the rows/columns. This is often accomplished by plotting your path before you begin to stitch. Similar to the journey a stitcher takes to create reversible Blackwork, ideally you want to begin and end in the same mesh square. This takes some practice and planning.

Linen Stitch

Start where indicated weaving over and under following the route shown in blue. The return trip is done with regular weaving (in red) and edge stitching (in green). Remember that when you turn corners or go to the next mesh square you must go around a mesh post and not cut diagonally across the back.

Begin you return trip and when you get to point A you will work an edge stitch (shown below) along the side until you get to point B. Weave two columns and turn the corner. Do the edge stitch from point C to point D. Weave two rows and turn the corner. Do the edge stitch from point E to point F turn the corner and continue the edge stitch to Point G.

« Back to Stitches

Written by: Ryan

Darning

While most references suggest you start stitching in the bottom left-hand corner, you can begin almost anywhere as long as you then follow the pattern and not jump over open mesh. Usually four passes will adequately fill the mesh square. If you are not going to shrink the piece and want a fuller look, then add another pass or two, but don’t overfill the mesh or you will distort the overall picture. Usually a “|” or “—“ is used on a chart to indicate the darning stitch and the direction you should stitch. Sometimes the mesh square will be a colored block and you will need to decide which direction to stitch.

« Back to Stitches

Written by: Ryan

Darning Filling Stitch

Cut and wrap the bars (Fig. A). Bring needle up in center space and “darn” each corner intersection separately. Pass the needle over the first bar going right, under the second bar, over the third and under the fourth. Now go in reverse direction by passing the needle over the fourth, under the third, over the second and under the first. Reverse and go over the first, under the second, etc. Repeat until size desired is reached. Wind thread around wrapped bar to next junction and work the second corner (Fig. B). When all corners are completed, place a center web (Fig. C). Work needle to outside block row and finish.

« Back to Stitches

Written by: Ryan